Setting the Clock

The system controller has an 8 to 24-hour built-in back up system to maintain the time of day. If the power is out longer than 8 hours, the time is lost and needs to be reset.

When dashes are flashing, press the square enter button. Advance through screen when it is flashing and you can set it.

Logix auto shows time

LD has gallons showing on display

1. Press the SET button. The display will flash 12:00
2. Use the UP or DOWN buttons to advance to the correct time. Note: there is a PM indicator, but no AM indicator
3. Press the SET button to accept the time of day selected
4. The control will advance to the DAY OF WEEK setting

Setting the DAY OF WEEK

The controller can be set for the specific day of the week. It is important to set this for proper system operation. A cursor will be displayed under “SU” (Sunday).

1. Press the SET button to make the cursor flash
2. Use the UP or DOWN buttons to advance the flashing cursor under the correct day of the week
3. Press the SET button again to accept the changes