Cleaning your injector
Cleaning your injector
- Unplug the power cord from the wall.
- Shut off water supply or bypass system.
- Push in red button and turn to backwash to relieve system pressure.
- Using a screwdriver, remove injector screen and injector cap.
- Clean screen using a fine brush. Flush until clean.
- Using a needle nose pliers, pull injector straight out.
- Flush water into injector screen recess of the valve body to flush debris out through the injector recess.
- Clean and flush the injector.
- Lubricate the O-rings on the injector, injector cap and injector screen with silicone lubricant
- Reinstall the injector, injector cap and injector screen. Caution: Do not over tighten the plastic cap. Seat the cap lightly into position. Over tightening may cause breakage of the plastic cap that may not be immediately evident.
- Plug in the power
- Slowly open the water supply or return bypass valves.
